Network Security

Can I deploy a 5510 or 5520 with all of the below modules/features integrated in a single box?1.AIP-SSM2.CSC-SSM3.Firewalling4.SSL/IPSec VPNs

I given attachment of th my network i want configure on both firwalls A and ip129.9.1.15,16,17 255.255.0.0 B and ip 129.9.0.220 255.255.0.0 i want commbined both networks trough 2 ASA 5510.plz send me configuration.

I have two routers 1841 and 851 . 1841 has a Static Ip where is 851 is on DHCP i want to created VPN connection between the specified routers, specify me a proper wan and link to perform the specified task using SDM

I have a Cisco 5510 at our HQ with 4 Cisco 857 routers connected to the HQ from the sub branches and appear not to be able to configure multi vpns between the offices for Exchange routing. Am I doing this properly or will this work with the hardware ...

Dear All,Can you please let me know the broad classification for type of logs that generates in any firewall.Regards

We have a pix firewalling a small lab in our company with the outside interface connected to one of our local lan's.Other than setting telnet 192.168.x.x 255.255.0.0 outside , is there anything else that is required?---Mike

We are running a Cisco ASA 5505 and remote clients are 871's. We currently use a EasyVPN configuration between the single ASA and our 13 871's. Today (1) out of the (13) tunnels is experiencing packet loss. I have power cycles the broadband router on...

ASA 5510 v8.0(3)Anyconnect v2.2Pretty simple setup, just a single group policy that has the Idle timeout set to 60 minutes.Testing it out, I connect with the anyconnect client and I can see session via the ASDM monitoring section and watch as the idl...

I have another problem that I just encountered after getting NAT set up correctly. I posted yesterday about a problem with using 2 WAN interfaces, once I got it all set up and working, now the inside static clients don't resolve hostnames, only IPs, ...

Input to the outside interface is maxed and has been for about an hour. I need help tracing either the source or destiniation so I can take preventative measures if necessary.I'm not very good at filtering the log!

Dear sir,i have tipical problem is i have two servers connected to unmanagble switch and from that switch to connected to one of of the port eth0/0 and i taken output eth0/1 and i conncted to my pc through the firewall i want to access my serversthro...

I have two remote vpn subnets that need to communicate. I have my access list as access-list No-NAT extended permit ip 172.16.140.0 255.255.255.0 172.18.3.0 255.255.255.0, however this does not seem to do the trick. Could these VPN's be terminating o...