Network Security

I have PIX 525 v. 6.3. I have CS ACS and it's ok with authenticating the PIX login. But I couldn't get accounting data from the ACS for the PIX, like the commandds enterd, anything the PIX admin has done. The ACS accounting works well with other cis...

i am not able to login to PDM3.0, it is showing me the error that Configuration problem.i can able to login to PIX510 by telnet, but i cant able to login using https:// mode.what could be the possible solution for this.

Hello,I am trying to enable threat detection with scanning-threat shun. The commands took with the config but when I run any nmap scans the ASA does not shun the host. What I am doing wrong?Thanks,Curt

We have configured the ASA5505 to give out DHCP IPs. The scope is 172.16.1.10 to 172.16.1.60. What are the commands for DHCP service to exclude certain IPs? Thanks.Said

Stupid question:If I have two ASAs, but only one IDS module, can I put the module in the primary ASA, configure it, and in the event of failover go without IDS functionality on the secondary?Two questions:1) Is this a Cisco supportable configuration?...

Hi,Is it possible to configure a SSO for OWA (Form Based) on the ASA 5510?Please Advise,Ziv.

I have 2 ASA 5520s with an ASA-SSM-20 installed in each. The ASA-SSM-20 in the primary ASA is not working correctly:Error: Cannot communicate with mainApp (getVersion). Please contact your system administrator.Would you like to run cidDump?[no]:I wo...

I am configuring a Cisco ASA5540 using ASDM (ASA OS ver 8.03 and ASDM ver6.03 respectively) and there seems to be several common TCP and UDP ports missing from the "predefined" services ports list, i.e kerberos(TCP/UDP 88), DCE endpoint resolution (T...

I have a 1800 router and my ISP blocks port 25 (smtp). I need to configure inspect and port-map esmtp to port 587, but I can't configure this. If i configure port-map on port 587 directly (not port-map esmtp), the applications not works correctly (ve...

Hi - I'm using ADSM 5.2 to configure a FWSM running 3.2.4 code. I would normally configure the FWSM using the CLI, but for some reason, if I enter host entries on the CLI, they don't show up on the ASDM. For example, I configure 3 host/IP address pai...

dear all,Please give the part number for Cisco services for IPS for 4260 IPS.We need to quote for the client for signature updates of this IPS modelThanksswami

Hi,Our remote network users VPN to a PIX 506e. We had an issue three weeks ago, whereby remote users were getting kicked for the tunnel to the 506e. We reloaded the PIX506e and the issue was resolved. Today creating VPNs to the 506e was slow and s...

Test bed configuration consists of Catalyst 6500 and 4255 IDS vith SW version 6.0. The traffic is captured using VLAN capture feature and send to the sensing interface Gi0/0 on IDS. The reset interface is Gi0/3, connected back to the Cat6K. Vlan 140 ...

When I configure subinterfaces on an ASA, how does the security level of the physical interface interact with the security levels of the subinterfaces? Can I make the subinterfaces security levels different from the security level of the physical in...