Network Security

I have a VLAN configured and trying to connect my other 2 locations that are using a VPN. This is what I'm thinking I need to do.Ex:HQ VLANs{PIX}route in 0 0 [Public]route in 192.168.1.0 255.255.255.0 192.168.5.23550 fa0/1 - 192.168.5.1/30 -> 192.168...

Hi allI want to know if it's possible (see attachment for detail) to manage multiple subnet within a Layer 3 switch (3750) through a ASA5520 with 802.1Q tagging.Refering to jpg file; the SQL and ACS subnet are only define in the layer 3 switch The DM...

Dear all,I setup the remote accesss vpn using active directory ldap, kerbi for authen and authro. It is works well but i am facing frequebt tunnel disconnections.Syslog shows that the clock setting bet AD server and ASA 10 minites different. After se...

... or sometimes after a while; it started a couple of days ago, 8.0.3 installed on December.First thing I presumed was a defective power supply so I opened the case and checked all connectors to see if they were properly fit etc.question is:I see a ...

Hi, how can I configure one-on-one "IP shift" NATting on PIX/ASA ? For example 202.100.1.16/28 <-> 192.168.2.32/28. So a.a.a.17 <-> b.b.b.33...a.a.a.19 <-> b.b.b.35...Can I code like this? I don't have the appliance to verify, anybody can confirm it?...

Hi,Any chance anyone knows the specific MIB's for an ASA 5520 and 2821 ISR?Finding it difficult to track down the exact ones I needhttp://tools.cisco.com/Support/SNMP/do/BrowseMIB.do?local=en&step=2Thanks,Denis

I have 4 - 871's running 12.4(T8) that connect to an ASA running 8.x code utilizing EasyVPN. The problem is that 2 of the 871's connect and pass traffic without issue but the other 2 connect only for about 5 minutes. The configuration are all the sam...

I am trying to allow SMTP through a PIX 525 running ver 7.2(2). When the banner comes back to the server it is 2's and astericks (*). I have done the "no inspection esmtp" commmand in the global policy, so that should turn off the inspection. However...

I'm setting up a new ACL on our PIX firewall (running version 7.x) to block FTP. Someone asked if I could enable FTP downloading for some machines but prevent from uploading. Is that possible? What would the ACL look like?

Hello,I have following problem with NAC 4.1.3 - it's happen sometimes that clients have NEWER virus definition than in NAC rules and checks database.And than clients can't get access to network. NAC rules updates are scheduled twice a day (should it ...

I want to start the asdm-launcher from the windows command-line with a specific asa ip-address (script). So i must only insert the username and password and not the ip-adress .Is this possible? Thx for your positive answer Andreas

HiI've got a pix 501 and I've permitted ALL icmp through the outside and inside access-lists, yet traceroute through this firewall still does not work, it just shows stars for all hops past the pix until the actual final destination. I've read a ton ...

Hi All, I have setup a lab to test ASA faillover situation. The lab is success that Secondary ASA can change standby mode to active mode once Primary ASA is failure. However, When I test stateful failover that use a PC to FTP file from FTP server. Th...