Network Security

Guys.Everytime I try to launch User Tracking, it shows that it failed to connect to the ANIServer.I've tried restarting the ANIServer which didnt work. I even ran reinitdb.pl (with and without the -restore switch),which still failed. Appreciate any h...

I have established a site-to-site tunnel between our two office bldg's, but I'm unable to ping between the two. Both IPSec and IKE negotiate and show active connections, but if I check the IPSec tunnels in the VPN status monitor, there are no decapsu...

I have activated the ARP inspection at FWSM of Cisco 6509. Is there an SNMP MIB to show ARP table info at FWSM of Cisco 6509? The "ipNetToMediaTable" MIB does not return anything.

I am configuring an ASA5520, which is acting as a Certificate server.The CA server is enabled and I have issued some client certificates.I have enabled the following commands:webvpn enable outside ssl certificate-authentication interface outside port...

Hi, ISP--R1--Firewall--R2--R3--Pc(webserver) ISP is terminated in the R1 router.To provide internet for users, Dynamic NATing are given in the rotuer(R1) level itself.R1 F0 ip is primary public ip and Secondary ip is private ip which is terminated ...

Hi all,I need a help with this one.We have configured one our physical interface (X) to be without an IP address and we have created on the same interface the VLAN interfaces (E, F, G, H). But because we have our PIX in failover we observed following...

Purpose - deny access to the firewall (save for specific exceptions) I always thought that if you specified some telnet hosts on the inside and SSH ones the outside that "it was implicit" that no other access could be made via these protocols. But to...

We have 2 sites with 2 ASA 5520s on Site A and a 3rd ASA 5520 on Site B.We have the 2 ASAs at Site A set as Active/Passive failover.We would like the firewall at Site B to also be part of this failover in the event of Site A being unavailable. Is thi...

We are setting up vrf's for different departmental domains and they will all come together in an FWSM module to govern access between the vrfs. Does anyone have any documentation on how to set up the FWSM for this? I need to come up to speed quickly ...

I have a 525 running 6.3 setup with 3 interfaces. Inside, branch, and dmz.The ip address range of my Head Office is 10.1.0.0 255.255.0.0 and my branch is 10.2.0.0 255.255.0.0.I have a server in the dmz with an IP address of 10.1.1.12.The firewall has...

I have installed the cisco VMS 3.1 Enterprise edition but after installation. I am not able to open it in web page. I have checked all the services and it was running fine. But after the new installation, it is not opening in internet explorer. I hav...

hello everyone, i got a question regarding SMTP extended:i have this image: c2800nm-advipservicesk9-mz.124-15.T.bin and Cisco Feature Navigator says that i have this feature but i cannot add the smtp extended protocol in any class-mapi need the smtp ...

Does anyone know of a tool that manages ASA/PIX/IOS ACLs? I am looking for a tool that can maintain shared policies and allow for local policies as well. Using the shared policies, I would like to be able to make one change to the policy and have i...

I've recently took over this new firewall to manage from another person who is no longer with the company. For some reason, when I've created a new NAT and applied a simple ACL, the ASA blocks it with the implicit deny rule.I can't seem to understa...