ASA 5510 V8.0(2)ASDM V6.0Whan I launch ASDM and then choose the configuration tab it no longer show me the configuration it just shows the start up wizard screen. This just broke as it was working fine and I could see and use everything under configu...
I've done a lot of HSRP using multiple routers but never had the need for doing it in a single router using multiple interfaces. So, I was wondering is it possible to do HSRP in one router using multiple interfaces to have one default gateway?
I've got a site that drops off and no longer sends VPN traffic. When I use the "sh crypto ipsec sa" command I see no "PKTS ENCAP" or no "PKTS encrypt". If I reboot the router everything starts working again. Is there a way to reset the tunnels using ...
I have 2 DS3's from point A to point B with both circuits in the same router at both ends. I have CEF enabled and I have the "ip load-sharing per-packet" statement on the interfaces but all of the traffic is only using one circuit. If I do a "show IP...
Ah yes, the DS3's are from the same provider but have diverse paths resulting in a different metric causing it to be absent from the routing table. Thank you, I new it would be something simple. This looks much better.
I've tried Pumpkin and Solarwinds. Pumkin crashes at 25megs and Solarwinds complains about the 16meg file size (file is too large). I tried to FTP it and my FTP session logs in and then hangs.Any ideas?
Looks like this isn't going to work for me as I'm using a PIX535 running 6.3.4 and the policy map/class map commands looks like they were introduced on the FWSM 3.1 code.Thanks anyway.
