Hello,I recently got my hands on an old 515 (128Mb RAM/16Mb Flash)that was running 5.2. I successfully upgraded that to 6.2(4), but then decided to put 8.0(3) on it, to make it more "user-friendly" since i am more familiar with the new ASA5500 family...
I have a PIX515E PIX with a failover device which is running on 6.3(4). I would like to upgrade this to a higher version. Please help me with the basic steps on what I should get ready and what I should consider.
Can someone please advise how Cisco determines the 50 user license limit.A company I do business with has a Cisco 501 which is used ONLY for remote vpn (Windows XP - using PPTP) users to connect to internal hosts. Internal users are routed to the in...
I don't quite get the regex in 5474-1 shown below. The '+' I think I get; if the data is a GET or a POST with enctype=application/x-www-form-urlencoded then spaces are encoded as +. But the regex also appears to be looking for a literal '%' and then...
ive experienced this with both asa and pix...does anybody know why acl needed for high security to low security??...even though i have no high security to low security for other connections?
I have very, very strange statistics on my sensor. I cleared it few minutes ago and now it is as follows: SigEvent Preliminary Stage Statistics Number of Alerts received = 60 Number of Alerts Consumed by AlertInterval = 0 ...
I am trying to configure site to site vpn tunnels with linksys routers. The linksys routers pick up IP addresses via DHCP. I tried to configure a 0.0.0.0 tunnel group but when the vpn traffic tries to establish, it hits the DefaultRAGroup tunnel gr...
Hi,I am using Cisco ASA 5510 ver 8.0 (2) with ASDM 6.0 (2)I have configured SSL based VPN access for my remote users. But when I enable Cisco Secure Desktop the performance of the access drops drastically and remote users are not able to work. If the...
I try to run:fixup protocol pptp 1723 however it doesnt work. i receive the error message "bad protocol". This works just fine in PIX IOS 6.1. Anyone have any ideas?
I'm testing Cisco NAC agentless in-bound layer2 mode following the CAM manual:•Configure the Quarantine Role•Load Nessus Plugins into the Clean Access Manager Repository,•Configure General Setup,•Apply Plugins,•Configure Plugin Options,•C...
If I upgrade my Cisco PIX 515E to Version 7.2 will I be able to leverage the WebVPN feature? In other words, with an upgrade to the version for my PIX 515E is the SSL VPN functioonality an option?Thanks
We have an application that negotiates a different port over time. We want to lock down our firewall to particular port(s), but this seems impossible to do with this apps. I know we can use inspection (fixup) on ftp, dns, sip, ... However, the applic...
I'm using a Cisco ASA5505 and a Linksys RV042 to establish a VPN tunnel betwen two subnets. VPN tunnel sets up ok - main screen on ASA shows IKE=1 and IPSec=1. But I'm not able to ping bewtween hosts on subnets connected by VPN tunnel.When I try to...
