Network Security

As I Can Block out ports Of chat software SKYPE.. I have a 505 PIX Cisco

The telnet and enable password on my PIX are not working. They were changed and the lines in the config read:password <password> encrypted. andenable password <password> encryupted.The password listed is the password that was typed in only it is in ...

I get teh following syslog message *only* on one VPN connection that is trying to be created from inside to a customers vpn concentrator on the outside via out ASA. Have several other ipsec vpn's that work just fine, there is always one isn't there.L...

Hi there,Is it possible to access a server located at the DMZ using its public IP address (static nat), from a server in the same DMZ or another station in another network interface (inside or management)? Will that be possible in the ASA? My custome...

I have a lot of fales positives of signature 5894 ("Storm Worm") in Subsignature 0 - especialy from host "static.ak.studivz.net". The signatur definition is just looking for "Server: ngin" in HTTP downloads which is realy unspecific in my point of vi...

When I try to initiate a vpn with ping of telnet xxxxx port xxx then the VPN tunnel doesn?t get established. If I use an application that uses the same port then it works.

We are starting to implement the CSA. One concern is the log file size on the workstation. Is there a way to limit the size of the log on the agent without manual purge or is there an auto purge feature build in the CSA agent? If there isn't how peop...

This is a tough and intermittent issue. Users vpn into the network using Cisco client version 4.6, sometimes cannot access e-mail (Outlook)or browse, ping the network. This usually occurs when the user is coming in on a wireless connection and is not...

How can I configure two ISP's with, each there on unnumbered ip routers, in the pix and do source routing?

Dear security men!we have an NAC applicane server.what do u offer for client agent?regards

I am testing the failover process (Active / Standby) on the FWSM modules.Setup: (2) cat6506's (2) FWSM modules configuredSwitch#1 - hosts primary FWSMSwitch#2 - hosts secondary FWSMSwitch#3 - Internet/Gateway routerI have the FWSM configured to...

Guys i m trying to install cisco SDM on router.....can someone please tell me how to enable http or https service on cisco router????

I've got a site that drops off and no longer sends VPN traffic. When I use the "sh crypto ipsec sa" command I see no "PKTS ENCAP" or no "PKTS encrypt". If I reboot the router everything starts working again. Is there a way to reset the tunnels using ...

Hello!My company has a very small network consiting of 15 users and a VPN between both sites using Cisco 831 routers. I was wondering if the was an affordable tool to analyze the logs that the IOS firewalls are producing?Thanks for any help.Chris Ed...