Network Security

Can an IPS module monitor traffic for (2) 6500s working in load balancing mode?

I was using a 2651XM with a DSL WIC to terminate an internet connection, perviously we were seeing 4500/680 for speeds from the "speedtest.net" website, also a directly connected computer on the DSL modem see's the same performance.Once we put the PI...

Hi there,I am very very new to cisco, so I need some help in trying to figure out how to block streaming traffic. Any help will be appreciated.Thank You

Hi friends,I have a PIX 6.3 where i am terminating a site-to-site VPN tunnel and a remote access VPN too. The current site-to-site VPN peer is a static peer. Now, i need to add another site to site tunnel on the PIX but this time with a dynamic VPN (...

hi,i am using ASA 5520 with 7.2(2) with 512MB memory. I have only Internet being accessed using proxy via this firewall. CPU load is <1% but memory is always >280MB and average is 256MB.Why ??Sarva

Please excuse my newbie question, but can someone please tell me how to open port 3306 on a Cisco Pix 501 firewall using Device Manager 3.0?

How do I remove an (FO) license from a PIX535 to make it to the default (R) license?

Hi, after we install new memory and VAC+ card to upgrade PIX515E from R version to UR version, the PIX515E stop boot procedure. there is no error message.CISCO SYSTEMS PIX FIREWALLEmbedded BIOS Version 4.3.207 01/02/02 16:12:22.73Compiled by morlee32...

Hello everybody,Does anybody know how much the 3des/aes license for the pix is? I know the des license is for free but not the 3des/aes license, isn't it?

I have confiured the below command in PIX: nat (inside) 10 192.168.128.0 255.255.252.0 0 0. If I configure system ip 192.168.129.100 subnet 255.255.252.0 GW: 192.168.128.6 (intf IP). Internet is not working. There is no ACL configured in Inside inter...

Dear All;I configured my PIX 525 in such a way that it should forward port 3389 for Remote Desk Top. I have passed these commands into PIX:static (inside,outside) tcp interface 3389 172.16.0.152 3389access-list RDP permit tcp any interface outside eq...

Hi.Has anyone implemented CS-MARS with ASA in active/standby, each with IPS modules?What is the procedure for adding the devices to CS-MARS - do I define each box separately -(remember the active and standby both have the same name) or do I just defi...

Hi,I configured the PIX firewall and want to allow the web access from one DMZ to another DMZ.But when ever the B.O user access my web server in D-DMZ from S-DMZ(B.O), the packets are always going to INSIDE lan.I have attached my network diagram and ...

Hello. We recently obtained Cisco ASA 5540 firewalls and I noticed they have an Aux port. Generally I disable this by doing line aux 0no execHowever, of course, the firewall 7.2 operating system has nothing similar. I checked the Command Line Referen...

i have pix515E IOS 7.04 installed at my network. yesterday i worked and configure pix interfaces, static NAT, syslog, static routes and access-list and then i left the next morning i came office and try to use NET there is no response, i check syslog...