Network Security

Hi,The ASA we have is running Cisco Adaptive Security Appliance Software Version 7.0(6) Device Manager Version 5.0(6)Some docs I have seen say the WEBVPN is a trial but does not say anymore than that. Is it limited by functionality or the number of c...

Hi friends,I had attempted to upgrade the WS-SVC-IDSM2 blade on Cisco 6509 (Sup 720) switch to SW ver 6.0(3) from Maintenence partition 2.1(2) but was unsuccessful. The IDSM-2 was initially running ver 5.1(3). The file that i tried was WS-SVC-IDSM2-K...

Looking to create a hub and spoke VPN with ASA devices. Will use ASA5505's in the branches. Looking to determine what model to use in the head office. There will be approximately 80 small branches connecting back. The 5510 says it will do up to 250 s...

I have a 2821 router with the advanced Ip sevices K9 package installed which includes the IPS that uses the sdf's. The last update on the SDF according to the software download page is 10 Dec 06. However, there have been many subsequent signatures re...

hi all,currently my compnay decided to buy an ips, i have a cisco 6509 one core siwthc, all my servers connected to the core and seprated through vlans, i want to make inline IPS from any vlan to other valn, 5 of my vlans have SVI, the rest is not so...

Im trying to get a dhcp address from my cable modem to my pix 506 e but it fails"ip address outside dchp setroute"somebody know how to get this working?

Hi,I've never worked with an ASA (5520) before but have managed to get it up and running and have everything configured. Tunnels are running, DMZ is working etc. I set up a syslog server and what I'm struggling with now is what to log? I find it diff...

What is the best way to create an exception rule for NetBIOS on the CSAMC? NetBIOS needs to be enabled because of resolving IP's within rules on the CSAMC.The process 'System' (as user NT AUTHORITY\SYSTEM) attempted to initiate a connection as a clie...

Is it possible to collect xlate information from a Cisco load balancer (CSS) for the purposes of sessionization and correlation in MARS?

Sir,i have two DSL Modems & Two Different Networks. i want that both Network traffic should be filtered through One Firewall means two in & two out ethernet Ports. Please help me that which firewall series i should use for it. Please reply me Soon.

Is it possible to remotely monitor this setup using SNMP via Orion? If the module fails, does it have an alert system built in, or can it be monitored remotely.

Is it possible to have 2 Internet connections to 1 Pix 515e running 7.2(2) code? I'm considering a design where there is a single firewall (only one available) but 2 paths to the internet instead of using 2 Pixs for redundancy. Is this even possible?

Hi folks. Can someone explain why I might be getting the following syslog from my ASA 5510:<166>%ASA-6-110001: No route to 127.0.0.1 from <IP address of ASA 'outside' interface>We do not have failover configured, however the 'internal control 0/0 int...

I need to remove a couple of outdated ACL's in my ASA, but when I use the command "no access-list outdated1", it says it's an incomplete command. I can't just go through and remove each line, as there are about 500 entries for each outdated acl I nee...