Network Security

What is the best defense against stealth scans of the network? I know this is a vague and open question.How do you prevent when signature detects a single TCP packet with none of the control bits, i.e. SYN, FIN, ACK, PSH, URG or RST flags set being s...

I dont know if this is the right forum for this problem but I hope someone here can help. I have a new virus/worm spreading across my network. It will first ping random addresses in any known subnets and then try to attack port tcp 1433, tcp 2967, tc...

I have config PPP multi-link with WFQ and added physical links to a multi-link group, with WFQ enabled. Physical links show queuing strategy as WFQ suspended and using FIFO.Is there a way to not suspen WFQ?thanks

Can you advise if there is some way to determine why this particular CEF process on slot 2 is running at 75% while the rest appears to be around 30%? Cairo#sho ip cef resource Hardware resource allocation status summaryGreen (Normal), Yellow (Caution...

I am currently running a PIX 515e software version 7.1(1). I am currently using a 255.255.255.192 subnet for my public addresses for static NAT. I am running out of addresses and would like to add another block of IPs from my ISP. If they are unable ...

Hello, i have a customer that has a CW LMS 2.6 managing more than 1000 equipments.He has enormous databases and the service level is very degraded.Is there any thing to do with the database to purge them or to depurate them????Thank you on advanced.

Hello-I have a 3000 series Concentrator. I am trying to set up a new Lan-to-Lan. The IKE Proposal I need to use will not show up in the drop down box in Configuration\Tunneling and Security\IPSec\LAN-to-LAN, all the rest of them do. If I go into Conf...

Hi,Anyone can help me to get the link for the ASA Active/Actice config example?I only see in CCO the Active/Standy Example with config and network diagram notes.Appreciate if anyone can send me a link.Many thanks, the config guides for ADSM 5.2. and ...

Hi,we have recently purchased an ASA5510 with AIP SSM module. I keep trying to login to the card with the "session 1" command but I get the bellow error when trying to change the default login password:login: ciscoPassword:You are required to change ...

I have Cisco ASA 5510 that when booted the lights of Power,Status,Active,VPN are all lit up except and green. The Flash light is red or not showing any color. Also i can't connect through it using the console port with com1 96800/8bits/parity none/st...

Have upgraded back to 7.22, also ASDM to 522, now I can not access via ASDM. I am using 2003 RADIUS for authentication, I get a username and password prompt, then nothing.Anyone know the answer?

Using the PDM on the 501, I am only able to add 2 DNS servers. Is it possible to add a third using hyperterminal?