Network Security

Hi all,I'm trying an old VMS 2.3 with IDSMC 2.0.1 to IPSMC 2.1 through VMS2.3 CD1, but during the installation process it appears an error telling me that ASANYs_SqlCoreDB cannot be stopped and asking to do it manually.This process doesn't appear amo...

Hello,I need to purchase another pix firwall (already have 501). Was wondering if i could get a comparison resourse some where (need to know the major diff. from 501 to 535). Also the major difference between PIX and ASA.ThanksDaniel

Hi I have a pix 501 and try to connect vpn with a 876 k9 . Can anyone help me to do this tnks !!!

We are using a Pix 535 firewall and we're trying to establish a VPN connection from inside our network to another network. (not site-to-site VPN).This is just a simple connection using the Windows VPN client. On the firewall logs we are getting:Deny ...

Hi,We have tried downloading the image IDS-4215-K9-sys-4.1-4-S91a.img from Cisco site but unfortunately we got the error message... "Error: DB: ip_check :3"Anyone in the forum can share this file.TIA.

I recently installed an 837 w/ CBAC (12.4) at a small office. I have enabled inspection for DNS, HTTP and HTTPS. I have found that most web pages display without trouble but a couple of sites are giving me trouble (www.usatoday.com). The page never d...

i have ASA, and i have 10Mb internet connection.i want to divide the internet 6mb in the DMZ interface and 4Mb in the inside interface. can i do that using ASA and QOS.

Is there a faster way of updating the CS-MARS devices than going through one at a time and applying the update pkgs (ex. 4.1.1 ->4.1.2 -> 4.1.3...)? Would there be any disadvantage to just grabbing the lastest recovery cd and rebuilding the entire bo...

Hi,Reading the PIX documentation (v7.2) I can find the following regarding logging host configuration: " If you specify TCP, the security appliance discovers when the syslog server fails and discontinues sending logs"Will the firewall recover syslog ...

We purchased a T3 to be our main Internet connection, we have a T1 now. I want to make the T3 the primary and the T1 our backup Internet connection. However we have a lot of static statements on the PIX, so I want to have a backup static route for ea...

I have three seperate networks that can not talk to each other. Is it possible to use one PIX 515E to VPN to these three different networks depending apon the VPN connection? If so how would I go about it?

Does anyone else have problems routing to the management port? I have a router with a 8 port L2 switch module. On my router I created a VLAN for a /27 network and created an SVI. I set the IP address the Mgmt port and then attached it to a port on th...