Network Security

I am attempting to configure a BGP connection between Azure and our network. After completing the configuration on both sides I am getting the following error.%FTD-2-106016: Deny IP spoof from (10.X.X.X) to 192.X.X.X on interface outsideIt is blockin...

Just replaced a 4120 and added to FMC, applied the health policy, but still not showing any information.Tried to run the modules but nothing is returned.On the pie chart at the top, it says 97.44% Disabled.Am I missing something. 

Is this FMC virtual Strong Encryption 3DES/AES license (L-FMCVIR-ENC-K9) included at zero cost? for Cisco 1120 NGFW Appliance. How to install and enable this encryption?

!interface GigabitEthernet1/1nameif outsidesecurity-level 0ip address x.x.x.3 255.255.255.0!interface GigabitEthernet1/2nameif insidesecurity-level 100ip address 192.168.1.1 255.255.255.0!interface GigabitEthernet1/4nameif dmzsecurity-level 50ip addr...

I have gone through the connection flag alphabets from Cisco website but I could not correlate them with real time connection logs. Someone please share some documents which has the clear info. Thanks in advance,, 

Hi everyone, I am new beginer for Cisco anyconnect. Recently,  we have a situation. we are using anyconnect (vpnclient-winx64-msi-5.0.07.0440-k9) on Microsoft windows server 2016, which is worked. Now, we will migrate to new server windows server 202...

Hello Community,on an FPR-1010 device (Version FTD 6.6.1), managed by FDM I want to do a simple static load distribution by using policy based routing.On CISCO ASA it is easy like this example:interface Vlan1 nameif inside policy-route route-map ROUT...

Cisco ASDM-IDM Launcher v1.9(5) not working

I am hoping I can get someone here to clear this up for me. I have discussed this in previous threads and I am still confused. The confusion I have is this. I am staging FTDs off the same subnet the FMC resides in so therefore to apply my configured ...

We are switching to an ftp server to replace an ancient tftp server to backup our configs to. Most of our switches are set up to write to this new ftp server, but I'm having some trouble with our ASAs. I can't seem to figure a way to write the config...

hello ,we have a device  ASA5520the version isCisco Adaptive Security Appliance Software Version 8.2(5)Device Manager Version 6.4(3)Compiled on Fri 20-May-11 16:00 by buildersSystem image file is "disk0:/asa825-k8.bin"Config file at boot was "startup...

We have an FPR 2110 (running version 7.0.1) managed by an FMC 1600, configured as:Transparent mode; Inline set for the inside and outside port. The GRE tunnel terminates on two L3 cisco switches, so we are not trying to terminate a GRE tunnel from a ...

i have the firepower 1120. i access to device from device manager. i don't know how reboot device? can i download firepower management center free and whic version. my device has software version 6.6.1-91