Network Security

HiI using RME Baseline Templates to deploy RTR commands to group of 450 routers 800 Series, The problem is that i need to use the dymnamic varaible of ip and I dont know what is the parameter ????the ip is the default gateway and also is the devicen...

hi all,Having a setup with a PIX runnin 7.2.1 where I need to do a full net-net static (ie. static (int, int) 192.168.0.0 <-> 192.168.0.0 ).Thus "exposing" the inside net, 192.168.0.0 to the outside.Now, in order for this to work without breaking the...

I am confused about the value that is returned in a snmp query to the 4250-sx for the interface speed. Could you please help me to understand? When I query the ids 5.1 x sensor with snmpwalk, it returns with a value of 10000000 which = 10 Mbpsroot:~#...

Hi,Is it necessary to configure something or PIX 6.3.5 has default started protect against DoS attacks like SYN-flood ?ThanksPeter

Hi, I installed a NM-CIDS-K9 Module into my 2821 router running 12.4.8 (C2800NM-ADVSECURITYK9-M). My IDS module is running 5.0(2)S152.0. The issue I have is that the Interface IDS-Sensor 1/0 of my router is going up and down every 10 seconds. I confi...

I push new signatures to a cisco ids sensor using the default setting, which is over port 443.Is it possible for me to change it to 22, so updates happen over SSH rather than HTTPS?

hi I have IPS 4240 - ver 5.0.2 . I am not able to start admin console from any other host other than those on the same network (class C). I have configured allowed host properly in the config. Please suggest.Please direct me to any url where the setu...

We are authenticating VPN users via a FreeRADIUS server (see www.freeradius.org). This works fine for username/password, but we don't seem to be able to pass RADIUS attributes back to the VPN, or at least not in a way that affects the user's session....

I have an IDSM-2 with version 5.0(2)S152.0 on a 7600 chassis. I am unable to manage the IPS using the IDM. When I try to log in, I get the following error "Error connecting to sensor. Failed to load sensor-errSystemError-ct-sensorApp.487 not respo...

Default the event viewer only support up to 5 IPSs. How to mke it support more that 5 , need to buy any upgrade license ? I had 6 units of IPS , now only 5 units is able to send event to viewer.Regards

When using a Global statement with a single IP address which suggests PAT; 64,000 and 65,535 are sometimes listed as the upper limit of hosts. Are these theoretical numbers or what is the actual number of hosts that can be really used with a PAT addr...

Can the asa-5520 (anti-x edition) be used as a IPS too? If so, how?

I just upgraded my network backbone to the 4507r switch using sup IV and netflow cards. I also upgraded my Internet and core routers to the 2821 and 2851 respectively. I will also be installing a ASA-5520 w/ csc-ssm-20 module. How should I proceed...

Hi Hope you can help me out here.We have home workers that connect via BT IP Stream (adsl) to our IT Department. On power up of the Draytek router(at the house) they are authenticated by our radius server and are given a 10.180.*.* address, this work...