Network Security

Its possible to allocate Ip address based on MAC address.???IoS 7.0 PIX 515E ??Or Ip addressess a assigned in turn??THX Laptom

We are experiencing intermittent issue with accessing the IDS Sensor and Security Monitor in VMS 2.2. So far, I have resetted the IDS Module 6509 with IDSM2

Hi,Could you take a look at the below capture to see if there is false positive at work. Thanks,Matt signature: description=Windows RPC DCOM Overflow id=3327 version=S188 subsigId: 6 sigDetails: \\\x3c400 chars>\ interfaceGroup: vlan: 0 participants:...

Hello,When will the IDS-sig-4.1-5-S197 be available for the 42XX line of sensors?Any info is greatly appreciated.David

How do I see if the TCP reset is working, I have IDM, IEV, IDS MC, and for some reason I cannot locate the informationThanks in advance

I am looking for the configuration method so that the VMS security monitor will display informational events in addition to low, med., and high events..The documentation I have found explains what the informational event is, but I cannot find out how...

when i telnet pix 7.0 from switch,i execute show run command.the information display half then stop.i must telnet again.but ping pix is normal.Is there something wrong?any help will be preciate.

Hi,I'm deploying IPS 4255 (5.0.4) at my customer site. I put the IPS between the internet router and firewall.Gi0/2 connected to firewall and Gi0/3 connected to router. Is it correct setup?We use default signature configuration.After deployed the use...

I have two concerns regarding Cisco NAC.Will it work for Cisco customers running something else than Microsoft on their clients?Why does Cisco not develop NAC towards LDAP instead of AD?As far as I see it this whole NAC thing is just a big Microsoft-...

This Sunday morning I'm upgrading our PIX to version 7.0. Any problems I should look for before, during or after the upgrade.

Is there any way to set JUST the signatures to default in 5.x? I tried doing a select all->default from the GUI but it eventually just times out with some rdep error. I also just tried doing it from the CLI using :(config)# default service signature-...

Started learning for the pix exams and wondering if there a simulator for pix 6.3 or 7.0 Or i need buy a real device to use for the learning?