Network Security

Is it possible to specify a MAC address for the outside interface on a PIX 501 running 6.2 and PDM 2?.

I have only one public ip adress, this ip address is already assigned to my pix outside interface. I would like to use this address in my "global outside X.X.X.X " command to nat internal trafic with the PIX outside address. When I do that I receive ...

We sold PIX 501 with 10 user sfw restricted version. How can manage this inside 10 IP addresses? Example - remove one IP of test PC's? LAN is about 25 hosts, wanted manualy put some privileg IP addresses into this 10 users pool.

Taking the example of the vpn3002, when it is configured as dhcp client, the number of retries is infinite.In the case of pix , the number of retries as dhcp client is from 4 to 16, it force to reload(unplug and plug the power cord) or via the CLI (w...

Dear All:I would like to know PIX support central manager and policy dispatch , Because i had 200 PIX 501 in branch office and i want manager and policy dispatch in headquarter

The PIX 501 documentation states that it supports a maximum of 5 simultaneous IKE SA's. Does this number refer to the IPSEC sessions that are terminated by the PIX? If I am not terminating these sessions at the PIX and instead use VPN client software...

Can i configure VLANs type 802.1q on the PIX Firewall with the o.s. ver. 6.2 ?Thanks in advance

I'm using a PIX 515 running 6.2 IOS with 3 ports. I have a W2K VPN Server in the DMZ interface that I would like to our W2K client to conntect to. Is this possible? If this is possible what do I have to do? I have setup a vpn connection using to PIX ...

Can I assign two different IP addresses from two different subnets to the same interface on PIX?ThanksS.

How can I timeout idle local hosts in pix 501 with 10 users license so that the new connections in the network can be given access.

I issued the show failover command on my primary pix box. It showed two of the three interfaces in normal mode, but the third ( a vpn tunnel) was in test mode. I was able to ping, and send traffic successfully going through the third interface; but w...

Does anyone know if it's possible to route traffic based on type (ie HTTP, SMTP) to a specific interface. We have one ISP connection connected to the Outside interface and another ISP connected to the DMZ interface. We'd like to force all out/inbound...

I want users to be able to surf the Internet, but not be able to download files.Is this possible?? Is there a protocol I can block?

I'm implementing a PIX 525 (2 interfaces only) and forcing all net and internally untrusted traffic through it ("PIX on a stick")--Is this feasible? How many users can I (NA) translate efficiently on a PIX?

I want to block users from using internet radio stations. What is the most efficient way to do this with a PIX?