we have two ASA in multicontext mode. When I connect to primary after few min it got disconnect when I try to login again it login to secondary device. 13:31:11 GMT/BDT May 9 2018Standby Ready Failed Interface check 13:31:24 GMT/BDT May 9 2018Fai...
Firepower 2110 supports Multi-WAN?
We had sold 2 IPS subscription licenses to our client for their two Cisco ASA Firepower modules. In return from Cisco, we received one software claim certificate containing the 1 PAK key. From its description, it is a Cisco ASA5515 Control License....
Dear, We have recently purchased two Firepower 2110 with threat, malware and URL license. Below is the BoQ of the new hardware Cisco Firepower 2110 Master BundleCisco Firepower 2110 ASA Appliance, 1USNTC-8X5XNBD Cisco Firepower 2110 ASA Appliance...
Hi,I'm rather new to the ASA box. recently I tried to use:asa#show ip route <dest_ip>which is not an asa command, ok. But show route does not accept parameter as an destination ip address. I have many outgoing interfaces (20 or so) which are only int...
Hi, I need to gain access of a ASA Context using ASDM. I am unable to configure ASDM image syntax (asdm image disk0:/asdm-xxx.bin). However the same syntax is valid when used on system context. Please advise how I can fix this. FW1/contex1(config)...
