can't create two auto nat rule, to port forward two services of a single server

[Eduard A.]

Hi, been struggling whole day now, can I port forward RDP (3389) and Oracle (1521) in my server?. My ASA is all gui, can't seem to put two auto nat rules with the same original IP. Appreciate your help. Please see attached image for hardware and software reference.

[balaji.bandi]

As per the information, there is no configuration available for us to verify what is wrong here.

Can you explain more what is the IP address external and internal, what is the configuration in place?

what test failed.

in case like to refer NAT on FTD below reference :

https://www.cisco.com/c/en/us/support/docs/security/firepower-management-center/212702-configure-and-verify-nat-on-ftd.html

[Eduard A.]

i am able to put in an auto nat that goes like this:
(inside) to (outside) source static (myserver) interface service tcp 3389 3389
when i try to repeat the process with the intent to add this:
(inside) to (outside) source static (myserver) interface service tcp 1521 1521
i get this error:
There is another auto NAT rule with the same original network. Only one auto NAT rule is allowed per each original network

[balaji.bandi]

Personally I do not believe Auto NAt works for you.

You can look for Manual NAT or PAT.