cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
76075
Views
5
Helpful
5
Replies

Cisco ASA 5506-X reset to factory settings (Reset button does not work)

huyan
Level 1
Level 1

Hi everyone,

I just bought a used Cisco ASA 5506-X  to learn CCNA Security. The seller said there is Firesource license on it.

 

I powered it on, I hooked up an ethernet cable to slot 2  and the other end to my laptop. My laptop got an IP 192.168.1.X. I followed the instruction, I tried to connect to 192.168.1.1/admin. However, there was a kind of time out error said the page takes too long to load.

 

I guessed I had to reset the firewall so I hit the reset button on the back of ASA for 5 seconds. Nothing happened.

 

Is there anyway I can do to access the admin panel through web browser? Or if I have to reset it, how can I reset it when the reset button does not work?

 

Thank you!

 

 

1 Accepted Solution

Accepted Solutions

balaji.bandi
Hall of Fame
Hall of Fame

If the button has been disable via the "no service sw-reset-button", it won't work.

 

if you have console cable connect let it boot.

 

config t
configure factory-default

 

another good document with steps :

http://www.mokonamodoki.com/how-to-factory-reset-a-cisco-asa-5512-x-ips

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post

5 Replies 5

balaji.bandi
Hall of Fame
Hall of Fame

If the button has been disable via the "no service sw-reset-button", it won't work.

 

if you have console cable connect let it boot.

 

config t
configure factory-default

 

another good document with steps :

http://www.mokonamodoki.com/how-to-factory-reset-a-cisco-asa-5512-x-ips

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Hi BB, Thank you!

I just ordered a USB to RJ-45 Console cable, I will try follow steps.

Hi,
I am at ciscoasa>

I type in ciscoasa>enable but it asked for password.

Since I don't have password. How can I bypass it to reset the ASA to factory default?


Thank you!

please ignore, I just found the solution here : https://community.cisco.com/t5/security-documents/asa-password-recovery/ta-p/3126046

Thank you all for help!

Just press Enter key without any password because the device doesn't come with any default password.

 


@huyan wrote:
Hi,
I am at ciscoasa>

I type in ciscoasa>enable but it asked for password.

Since I don't have password. How can I bypass it to reset the ASA to factory default?


Thank you!

 

Review Cisco Networking for a $25 gift card