Solved: Cisco ASA 5506-X reset to factory settings (Reset button does not work)

huyan · ‎11-13-2018

Hi everyone,

I just bought a used Cisco ASA 5506-X to learn CCNA Security. The seller said there is Firesource license on it.

I powered it on, I hooked up an ethernet cable to slot 2 and the other end to my laptop. My laptop got an IP 192.168.1.X. I followed the instruction, I tried to connect to 192.168.1.1/admin. However, there was a kind of time out error said the page takes too long to load.

I guessed I had to reset the firewall so I hit the reset button on the back of ASA for 5 seconds. Nothing happened.

Is there anyway I can do to access the admin panel through web browser? Or if I have to reset it, how can I reset it when the reset button does not work?

Thank you!

balaji.bandi · ‎11-13-2018

If the button has been disable via the "no service sw-reset-button", it won't work.

if you have console cable connect let it boot.

config t
configure factory-default

another good document with steps :

http://www.mokonamodoki.com/how-to-factory-reset-a-cisco-asa-5512-x-ips

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post