12-26-2018 06:03 AM - edited 02-21-2020 08:36 AM
Hello there, I turned on my asa 5510 today and I am getting these and and after a while drops me offline
Launching BootLoader...
Boot configuration file contains 2 entries.
Cannot find disk0:/flash:/asa917-13-k8.bin
Error 15: File not found
Loading disk0:/asa917-13-k8.bin...
Platform ASA5510
Loading...
IO memory blocks requested from bigphys 32bit: 13805
dosfsck 2.11, 12 Mar 2005, FAT32, LFN
Starting check/repair pass.
Starting verification pass.
/dev/hda1: 112 files, 11410/31180 clusters
dosfsck(/dev/hda1) returned 0
dosfsck 2.11, 12 Mar 2005, FAT32, LFN
open /dev/hdb1:No such file or directory
dosfsck(/dev/hdb1) returned 1
mount: mounting /dev/hdb1 on /mnt/disk1 failed: No such file or directory
mount: mounting /dev/hdb1 on /mnt/disk1 failed: No such file or directory
Processor memory 847249408, Reserved memory: 68157440
!WARNING: BOOT variable added, but unable to find disk0:/flash:/asa917-13-k8.bin
*** Output from config line 58, "boot system disk0:/flash..."
Solved! Go to Solution.
12-27-2018 12:26 PM
sad to hear that, if you have some console access and you able to see anything we can able to help you to sort.
since you concluded dead, we no longer proceed further, any 5510 is eol already.(since u do not have contact cisco can not RMA also the unit)
worth trying new gear, 550X-X model with FTD.
if you do not require further asistance here, close this thread will be appriciated.
12-26-2018 06:52 AM
Try format flash ? as mentioned below steps : (if not raise a TAC case for RMA) - make sure you have backup of the configfile.
12-27-2018 09:21 AM
Hi, yes, I managed to bring it to boot normaly, the only thing that seems wrong is the following
open /dev/hdb1:No such file or directory
dosfsck(/dev/hdb1) returned 1
mount: mounting /dev/hdb1 on /mnt/disk1 failed: No such file or directory
mount: mounting /dev/hdb1 on /mnt/disk1 failed: No such file or directory
12-26-2018 07:27 AM
Before formatting flash I would open the chassis (lots of screws) and reseat the internal CF (Compact Flash) card.
12-26-2018 09:19 AM
12-26-2018 11:24 AM
after format flash you still have issue ?
12-26-2018 11:28 AM
omg I lost all the files secret files directories all.all I have is the asdm binary and asa binary.
12-26-2018 11:29 AM
it doesn't boot anymore it loops all over again
12-26-2018 02:03 PM
HI!
I managed it to write to flash the asa823-k8.bin it boots my running config is
ciscoasa# show conf
: Saved
: Written by enable_15 at 21:51:01.909 UTC Wed Dec 26 2018
!
ASA Version 8.2(3)
!
hostname ciscoasa
enable password 8Ry2YjIyt7RRXU24 encrypted
passwd 2KFQnbNIdI.2KYOU encrypted
names
!
interface Ethernet0/0
speed 100
duplex full
nameif outside
security-level 0
ip address 10.1.1.2 255.255.255.0
!
interface Ethernet0/1
speed 100
duplex full
nameif inside
security-level 100
ip address 192.168.1.2 255.255.255.0
!
interface Ethernet0/2
shutdown
no nameif
no security-level
no ip address
!
interface Ethernet0/3
shutdown
no nameif
no security-level
no ip address
!
interface Management0/0
shutdown
no nameif
no security-level
no ip address
!
boot system disk0:/asa823-k8.bin
ftp mode passive
pager lines 24
mtu inside 1500
mtu outside 1500
icmp unreachable rate-limit 1 burst-size 1
no asdm history enable
arp timeout 14400
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
timeout tcp-proxy-reassembly 0:01:00
dynamic-access-policy-record DfltAccessPolicy
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
crypto ipsec security-association lifetime seconds 28800
crypto ipsec security-association lifetime kilobytes 4608000
telnet timeout 5
ssh timeout 5
console timeout 0
threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
!
!
prompt hostname context
call-home
profile CiscoTAC-1
no active
destination address http https://tools.cisco.com/its/service/oddce/services/DDCEService
destination address email callhome@cisco.com
destination transport-method http
subscribe-to-alert-group diagnostic
subscribe-to-alert-group environment
subscribe-to-alert-group inventory periodic monthly
subscribe-to-alert-group configuration periodic monthly
subscribe-to-alert-group telemetry periodic daily
Cryptochecksum:0be9e9f4638202c023718a39e89866eb
The problem is I get these at start :
12-26-2018 02:08 PM
dosfsck(/dev/hdb1) returned 1
mount: mounting /dev/hdb1 on /mnt/disk1 failed: No such file or directory
mount: mounting /dev/hdb1 on /mnt/disk1 failed: No such file or directory
what does this means?
12-26-2018 02:33 PM
FORGOT TO MENTION THAT BY MISTAKE I ERASED THE WHOLE FLASH.I THINK THAT'S A HIDDEN PARTITION.HOW DO I RECOVER THESE FILES AND HIDDEN FILES/DIRECTORIES?
12-27-2018 10:57 AM
UNFORTUNATELY THE DEVICE DIED, MOBO OR RAM I DUNNO I WILL DONATE IT FOR PARTS.DOESNT POWER UP ALL THE TIMES.
12-27-2018 12:26 PM
sad to hear that, if you have some console access and you able to see anything we can able to help you to sort.
since you concluded dead, we no longer proceed further, any 5510 is eol already.(since u do not have contact cisco can not RMA also the unit)
worth trying new gear, 550X-X model with FTD.
if you do not require further asistance here, close this thread will be appriciated.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide