Hello,Sometimes (once a month) occurs issues related to tunnel between Cisco router (our side) and Adaptive Security Appliance (other company).Problem disappears if tunnel is initiated from Adaptive Security Appliance side.How to fix this problem?
Hi everyone,If we config ASA with command belowlogging host inside 192.168.1.50Above command will send all log messages to server 192.168.1.50 right?If we also config command belowlogging device-id ipaddress inside What does above command do?will it ...
Hi,I'm just playing around with a few ASA's and wondering what allows return HTTP traffic into the firewall? Also, what other traffic is allowed by default like HTTP?Traffic is originating from a higher security interface (inside, 100) to a lower sec...
I am interested in getting all of my Cisco routers and Switches (with IOS <= 12.2) to use Azure MFA for SSH login. I do not want to use ASA or ISE or anything else like that. I would like to just authenticate them against a RADIUS or TACACS+ server, ...
hi there
I have this Meraki MX65W, per description from our client:
Meraki MX65W serial number xxx-xxx-xxxx since we have had some problems with the equipment; I'll tell you briefly. 1. We tested the equipment in the Regional of YYYYYYYYY, the same...
Just looknig for some advise in regards to keeping ACLs, objects, etc. clean and manageable. I know in a large prod environmnet, constantly adding IPs to block, adding rules, etc. can lead to a messy harder to understand ASA with rules on top of each...
Hi,
we have a customer has two FP9300 chassis with two FTD security module per chassis. the customer asked for a cluster deployment
the question is can we have intra chassis cluster for each chassis using the two security module per chassis and hav...
Hi all,I think i have a very simple question. We have a server making a lot of HTTPS connections to different IP's. We have a a specific rule in our ACL for this traffic. When building the firewall rules, i still noticed a lot of hits on the permit i...
Hi Guys I would like to upgrade the software version of our ASA 5508-x .. Currently it is at level 9.6(4)3 but I see two directions that I could go::I could upgrade to 9.6.4.8or I could upgrade to 9.9.2.1which direction should I go? How ...
Hello, I have a Firepower 2110 running a multi-context ASA 9.9(2) instance. The chassis is configured and synchronized with an NTP server, but the ASA clock is still wrong. I cannot find commands in the ASA instance to synchronize with an upstream N...
There are already a few of these questions like this on here but the solutions don't quite line up with mine so bare with me please, I'm still learning this. I have an ASA 5525x running 9.8bin. I'm trying to put a sourcefire module on it. I've downlo...
hi Team getting below error while enable IKE feature in FDM "unable cryptography types are currently restricted by the licensing status of the device" as per my investigation encryption license comes with base license to make IPSEC tunnel. LicenseDur...
I am new to ASAs, but I am trying to ensure connectivity between my internal LANs which hang off a subinterface. Any reason I am unable to ssh/ping 192.168.255.129 from the GreenNET network if the same security traffic is enabled? interface Port-chan...
