09-21-2016 04:26 AM - edited 03-12-2019 01:18 AM
Hi Experts.
I would like to know about of Firepower . Can I configure ASA 5525 Firepower Service with ASDM . I can not see Firepower
configuration Tab at the ASDM . Please help me and Thanks. ( Some people say me to configure with Firepower Management Center )
09-21-2016 05:54 AM
You can use ASDM but i would recommend using the FireSIGHT management center. You can download a virtual appliance and run it in VMware.
https://software.cisco.com/download/release.html?mdfid=286259687&catid=268438162&softwareid=286271056&release=Rules%20Updates&relind=AVAILABLE&rellifecycle=&reltype=latest
Also check in CLI that the module is running and all is good. Paste the command
"show module sfr details"
Paste the result of the command here in the forum.
Good luck!
09-21-2016 08:04 PM
Hi Jon ,
I only would like to configure with ASDM because I do not have FireSIGHT management center . I have heard If I use FireSIGHT Management center , I need to buy license . I don't want to buy License . So Please help me how to configure with ASDM . The problem I saw is Firepower configuration tab that is not appear in ASDM . I can configure Firepower with CLI .Do I need to configure with CLI for using with ASDM ? .
I am using ASA software version 9.5.2 , ASDM version 7.6.1 , FireOS 6.0.0.1 .
09-22-2016 03:18 AM
I think the Firesight management is free for 2 units.
Do you see the Firepower Status Tab in ASDM ?
If not try to go down to ASDM 7.5.x.
11-04-2016 03:53 AM
Hi Guys
Sorry to say but Firesight Managment Centre is not free you do need a licence to manage it
All the best
Roy
09-22-2016 07:49 AM
Have you done the basic setup of the FirePOWER module (give it IP address, gateway etc.) and do you have the management port of the ASA connected to the network?
show module sfr detail
...will confirm.
The FirePOWER module uses that interface and it must have network connectivity to the workstation you are running ASA on via that path.
With that in place (and assuming you haven't registered the module to a FirePOWER Management Center), it should be manageable via ASDM.
The prerequisite software versions are ASA 9.5(1.5)/ASDM 7.5(1.112) and FirePOWER 6.0 or later so you should be OK with that.
09-22-2016 09:11 PM
09-23-2016 02:03 PM
The problem appears to be as I highlighted previously: "assuming you haven't registered the module to a FirePOWER Management Center".
If you check the screen shot for FirePOWER module detail, you will notice it says "DC addr: 192.168.0.200". This means that the module has been configured to register with a Defense Center (old name for FirePOWER Management Center).
You cannot manage a FirePOWER module from ASDM if it is configured already to be managed from DC / FMC.
If you look all the way at the bottom of the "ASA FirePOWER Status" tab of ASDM home page it should indicate that you can manage it via the Management Center and show a link to the configured one (assuming the configured registration has completed).
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide