Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

We're looking at deploying 40+ Firepower ASA modules across our network (multiple sites) and I'm trying to find the best (read: fastest, least administrative) way to bring these modules up to 5.4.1.7 from 5.4.1.0 - base system image - to 5.4.1.7 whic...

Hi ! Please help me  to configure for  nat  a server into internet ,the Subnet is laying in Internet router. The internet router has one primary address and two secondary IPs configured. I want to publish the server using secondary subnet of the inte...

narayanan_b by Frequent Visitor
  • 853 Views
  • 3 replies
  • 0 Helpful votes

Network discovery in Firethreat Defense does not recognizes the OS and version for F5 ltm devices that are load balancing, therefore it flags those divices as compromised. Just wanted to know how would you deal with those devices? would you exclude ...

JD CZ by Visitor
  • 1216 Views
  • 2 replies
  • 0 Helpful votes

if i want to capture packets of IKE phase 1 using capture command , is this the right command  capture match udp eq port 500 eq port 500 i found this in cisco document  ikev1/ikev2 - Captures only Internet Key Exchange Version 1 (IKEv1) or IKEv2 ...

I have what must be a simple issue... Setup is per attached. I am unable to ping the FirePOWER address from anywhere (except from the physical ASA itself). My L3 Switch is the DG. Some details from the FP module ----------------------[ eth0 ]-----...

GRANT3779 by Spotlight
  • 4785 Views
  • 5 replies
  • 0 Helpful votes

Dears please find the attached topology, Questions: Please correct me if i m wrong I m planning to create two context on the ASA and the traffic these 2 context will receive is from 172.20.1.0/24,, 2.0,,3.0,,,4.0 etc etc Both context inside interfac...

Hi, I'm just checking here to see if anyone else is aware that in the latest release of Cisco Firepower Management Center there is not audit trail for changes to the access control policy. Now I consider the ability to log policy changes to be a re...

alaporte3 by Frequent Visitor
  • 1270 Views
  • 1 replies
  • 0 Helpful votes

I know this is a Cisco forum but a lot of talented people visit these sites and may hopefully be able to point me in the right direction. We are trying to implement a new Bluecoat Proxy ASG running version. The intent is to use the same proxy for mor...

Review Cisco Networking for a $25 gift card