Cisco ASA 5585-x SSP 20 firmware upgradation

[sv7]

Hello All,

Going to upgrade my Asa 5585-SSP 20 from version 9.8(4)32 to 9.14(2)

Found some article that to manage firmware 9.14(2) need asdm version 7.13(1.101). But asdm version 7.13(1.101) is not supported on ASA 5585 device. 

Can anyone please help me regarding this.

Please find below my device show version output and Cisco compatibility article

Cisco asa# show version 

Cisco Adaptive Security Appliance Software Version 9.8(4)32 

Firepower Extensible Operating System Version 2.2(2.138)

Device Manager Version 7.12(1)

Compiled on Mon 16-Nov-20 12:56 PST by builders

System image file is "disk0:/asa984-32-smp-k8.bin"

Config file at boot was "startup-config"

Ciscoasa up 241 days 15 hours

Hardware: ASA5585-SSP-20, 12029 MB RAM, CPU Xeon 5500 series 2133 MHz, 1 CPU (8 cores)

Internal ATA Compact Flash, 2048MB

BIOS Flash S25FL032P @@ 0x0, 4096K

https://www.cisco.com/c/en/us/td/docs/security/asa/upgrade/asa-upgrade/planning.html#id_59423.

Please guide me 

[Amine ZAKARIA]

Hello,

I have checked the last version of 5585-x, seems last version is 9.12.4 and not the 9.14 you have mentioned 

[balaji.bandi]

ASA 9.12(x) was the final version for the ASA 5512-X, 5515-X, 5585-X, and ASASM.

as per the document you can only go upto 9.12.X (Looks this bit confusing here, need to verify this)

[sv7]

Hi Balaji,

Mistakenly i have written 9.14(2) instead of 9.12(4) only. My concern regarding the Asdm support to manage the device after upgradation. Currently i have installed 7.12(1) version of asdm but as per cisco article it requires 7.13(1.101). Would my device ASA 5585-SSP-20  suppports Asdm version 7.13(1.101). Attaching the cisco compatiblity article below.

https://www.cisco.com/c/en/us/td/docs/security/asa/upgrade/asa-upgrade/planning.html#id_59423.

[balaji.bandi · Accepted solution]

this helps you :

[sv7]

Thank you balaji .

Yes i saw this it shows asdm 7.13(1.101) supports my device ASA5585-SSP-20. But there's another article which says ASA 5585-SSP-20 supports asdm image max 7.12(x).. and to manage 9.12(x) version requires 7.13(1.101) asdm version

Attaching image. Please let me know where im lagging.

[sv7]

Thanks balaji.

My activity got completed successfully.