08-26-2020 02:01 PM
Hello Guys, @Mohammed al Baqari @balaji.bandi @Rob Ingram @Marvin Rhoads
I am planning to update firmware from 9.9 to 9.12.3.12 including ASDM 7.14(1). I already upload both images to both unites.
I will update the standby firewall first and boot it with a new image and make it primary and the repeat same process with the Active unit.
I need to know which commands I need to use to make a new image as a primary boot image and new ASDM image as the primary ASDM image?
I want to make sure if reboot happens in future ASA always boot with the new image.
Thanks,
Solved! Go to Solution.
08-26-2020 02:07 PM
here is the complete steps :
Note :
1. backup the configuration out of the box.
2. you should not see any downtime - but always suggest to do in a maintenance window.
3. is this FW running a long time, make sure check the failover working as expected and reload the unit before the upgrade, so you know it working as expected before the upgrade.
08-26-2020 02:07 PM
here is the complete steps :
Note :
1. backup the configuration out of the box.
2. you should not see any downtime - but always suggest to do in a maintenance window.
3. is this FW running a long time, make sure check the failover working as expected and reload the unit before the upgrade, so you know it working as expected before the upgrade.
08-26-2020 06:49 PM
Hello @balaji.bandi
I update 5525x from 9.4(4)36 to 9.12.3.12 and standby ASA did not came back online. please advice the next steps.
Thanks,
08-26-2020 08:26 PM
If the standby unit is offline then you should attached console cable and open a session to it using your terminal emulator software.
Reload from power on and capture all of the output in a log file and share it here.
08-27-2020 02:25 AM
As per the orginal post you are upgrading from " firmware from 9.9 to 9.12.3.12 including ASDM 7.14(1)"
as per your reply you upgrading from "9.4(4)36 to 9.12.3.12" - that is ok but we want to be sure some time what is the version.
Some time may required upgrade path (not in this case)
Please confirm the steps you followed - also connect Console cable to see is that gone in to ROMMON ?
have you removed old boot reference ? after adding new Boot reference ?
08-27-2020 10:13 AM
Hello @balaji.bandi @Marvin Rhoads
I will connect to the unit and will share the output.
I uploaded the ASDM and software image to both units by using the ASDM File manager. I log in to the standby unit by using the standby IP address and change the boot image and asdm image. I deleted the old boot image commands and replaced it by a new boot system image disk0:/----.bin. Then I rebooted the standby unit but it never came back.
Thanks,
08-27-2020 11:04 AM
Hello @balaji.bandi @Marvin Rhoads
The firewall was booted but firmware update deleted the failover interface command as it was configured with APIPA IP and 9.4 OS was working with it but 9.12 did not like.
Adding that command fixed the issue.
Thanks
08-27-2020 11:06 AM
Thanks for the input -glad all went well at the end.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide