Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

We have following hardware:Cisco Firepower 1120 Threat Defense (78) Version 6.6.1 (Build 91)Cisco Firepower 4110 Threat Defense (76) Version 6.4.0.4 (Build 34) Netflow collector does not understood Netflow exported from FTDs above. Found with Wiresha...

Hello All,   Need to upgrade my ASA 5525-x with firepower Services managed by virtual FMC. I have gathered compatibility matrix of between ASA and asa firepower Services. Current Asa version 9.8(3)  Target version 9.14(2) Current FMC version 6.2.3 Ta...

vishal77 by Level 3
  • 2124 Views
  • 4 replies
  • 0 Helpful votes

We’ve faced an issue from FMC that’s when we try to edit the ACL policy, (Policy >> Access Control>>Access Control Policy Editor), it can’t be loaded and after a minute of loading, it automatically goes to Summary Dashboard Page.I’ve tried changing t...

SaintEvn by Level 3
  • 2426 Views
  • 2 replies
  • 0 Helpful votes

Dear ALL, I'm looking to setup the AnyConnect VPN service, our FMC are using internet IP to connect the FTD FW(no any VPN), i had added the AD server under "integration->Realms", but the connection always failed.I would like to know the AD server is ...

Hi, I need clarity on firepower vrf as we are planning to go for vrf at firepower.(FMC 2600 with version 6.6.1 is managing FTD9300 6.6.1 in HA)1. if i want to do route leakage from vrf-a to vrf-b, how many routes i can do leakage. what are the method...

Vishnu_RR by Level 3
  • 1305 Views
  • 0 replies
  • 0 Helpful votes

Hi All, The company I work for has a few ASA 5525-X firewalls in production, and they seem to be working great. We currently do not have the Firepower modules installed as we filter outbound traffic heavily, only a few IPs can get out. I looked up on...

synology-nas by Community Member
  • 1153 Views
  • 1 replies
  • 0 Helpful votes

Hi,I need some clarity on FTD, FXOS and FMC.If I configure TACACS+ for FCM, and Radius for FMC, based on what kind of authentication method that FTD would work.Recently i removed TACACS+ configuration for FCM, so i am not able to login FTD with AAA c...

Vishnu_RR by Level 3
  • 2900 Views
  • 2 replies
  • 0 Helpful votes

Hi Guys, I just want to double confirm my understanding for this feature ISE acts as a pxGrid Controller and FMC subscribes to the controller to receive session data. Note: we have a normal install of ISE not ISE PIC... (Not actually used or installe...

Hey We changed the PUBLIC IP in one site...and now we are trying to establich new IPSEC TUNNEL ​between both sites (CISCO ASA 7.2 - it was qworking before public IP change) .I was able to establish the tunnel but i cannot ping both ends\remote networ...

lmel by Frequent Visitor
  • 1963 Views
  • 5 replies
  • 0 Helpful votes