- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-18-2023 09:50 PM
Hi everyone
Does the Cisco Firepower 1120 have a virtual firewall feature, and if so, how can I create one?
thank you
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-18-2023 10:50 PM
Hi @WanisaCh,
On FPR1120 HW you can run 2 SW versions - ASA or FTD. On ASAs, you can run multi-context mode, with up to 5 contexts (will require additional license). On FTD, concept of virtualization is called multi-instance, but it is not supported on FPR1000 series. However, what you could also do is can be achieved with VRF-Lite concept, which is supported on FPR1120, with up to 5 virtual routers (you can find config guide here).
Kind regards,
Milos
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-18-2023 10:50 PM
@WanisaCh hi ys. check blow. base license have only 2.
https://www.ciscopress.com/articles/article.asp?p=426641&seqNum=2
Good luck
KB
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-18-2023 10:50 PM
Hi @WanisaCh,
On FPR1120 HW you can run 2 SW versions - ASA or FTD. On ASAs, you can run multi-context mode, with up to 5 contexts (will require additional license). On FTD, concept of virtualization is called multi-instance, but it is not supported on FPR1000 series. However, what you could also do is can be achieved with VRF-Lite concept, which is supported on FPR1120, with up to 5 virtual routers (you can find config guide here).
Kind regards,
Milos
