03-31-2020 07:08 AM
Hi,
I have console and management (eth0 port which is labeled as '1') connections to 2 FMC 1000 devices. I am working on getting these configured. I can get to the console connections for both. However the management connection on device 1 takes me to FMC login page as it should but the device 2 takes me to the CIMC GUI instead. I have verified the cables are connected to same ports (console and 1) on both devices. Can someone please help me with the fix here. Thanks
Solved! Go to Solution.
04-01-2020 02:35 AM
If they are console messages (not CIMC GUI), then to direct console messages to the physical serial port: sudo /usr/local/sf/bin/configure_console.sh serial
The management interface should then behave normally.
If it's actually the CIMC GUI then I am at a loss on that one. I'd open a TAC case if that is what you are seeing..
03-31-2020 08:00 AM
Hello.
Maybe im wrong, but management port so the "management" is signed and located up to console port. I think, you need to check your physical links.
03-31-2020 08:28 AM
03-31-2020 09:18 AM
What exact hardware models are used? Is your fmc virtual or not? What model firepower 1000 series are you using?
03-31-2020 10:53 AM
There should not be a CIMC GUI on the FMC 1000.
Could somebody have changed it to redirect the shell output to the management interface?
03-31-2020 12:22 PM
03-31-2020 01:50 PM
Yes, make foto of all devices and links between it.
04-01-2020 02:35 AM
If they are console messages (not CIMC GUI), then to direct console messages to the physical serial port: sudo /usr/local/sf/bin/configure_console.sh serial
The management interface should then behave normally.
If it's actually the CIMC GUI then I am at a loss on that one. I'd open a TAC case if that is what you are seeing..
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide