Resolved! Firepower licenses status: Failed
A couple weeks ago I added new licenses to my FMC and everything seemed fine, today I logged in and I find this, any idea what is happening?
Forum Posts
Hi All ,I try to find the maximum VTI (Virtual Tunnel Interface) on Firepower (ASA Image) . I found the value is 100 but I'm not sure this value is correct or not ? Please advise me for my concern.
Hi People,I am using ASA ASA5520 SW version 8.2(5)57I have many subinterfaces in my ASA. The relevant ones are below,GigabitEthernet0/1.6 DMZ 100GigabitEthernet0/1.56 WITNESS 74 I have allowed traffic from an IP whose route is pointing to DMZ, to an ...
Please check out the NetSec Public Announcement for our updated YouTube Channelhttps://community.cisco.com/t5/security-documents/https-cs-co-netsec-youtube/ta-p/4156821
Hi All,I would like to monitor IP NAT POOL If IP NAT Pool Full how can monitor this situation ? Is it trigger or send log for Nat Pool Full ?
We are getting too much log messages from fmc. ‘Session closed for user rootSession opened for user root’ This messge is coming repeatedly. Is it normal?
Resolved! FTD can´t be added to FMC
Hello Folks!I converted an ASA to FTD and now I can´t add to FMC.I can ping the FMC by ping system, the FMC can ping the FTD, at some point appear as completed in the show managers, but a few seconds later disappear and the device didn´t appear in th...
Currently having an issue with an ASA I am configuring where the NAT rules are being ignored. I am able to get to the external IP of the ASA but not to any devices on the inside. Connecting directly onto a server on the inside, I can see that whils...
We're looking at migrating our ASA-5510 to a Firepower 2110. Is there a path to convert the existing configuration to something that can be imported into the Firepower? Thanks
Hi All,I got some issue when i try to connect two ip management from different ASA. So i have two ASA, ASA1 has ip management 10.72.151.x (vlan 151) and ASA2 has ip management 10.72.161.x (vlan 161), they in same security level 100. i try to connect ...
Greetings to everyone, i would like to ask ,which is the best way to backup the configuration of firewall firepower 1140 running an FMC v6.6.0.Thanks in advanced
Hello everyone. The switch is configured to log in through the ISE. After updating from 16.9 to 16.12 the switch, authentication failed. There are no logs on the ISE when logging in with any account.If you connect with a local account, then enter the...
Is is possible to periodically change the meeting link for a reoccurring meeting?
Dear friends,I have done failover for firewalls umpteen number of times but yesterday it failed for some reason.I had replaced the failed primary unit with a fresh one and i had expected that it will detect the secondary unit as active and try to beg...
Hello community, We integrated our FMC with the Syslog server to send Intrusion and Security Intelligent event and we can see them coming from the FMC, however, we see also rarely some event from the FTDs as well We didn't enable the FTD logging bec...
