cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
406
Views
0
Helpful
1
Replies

Cisco FTD 4140 not able to register with Firepower Management 6.1

Pranav Gade
Level 1
Level 1

Hi All,

We are having Cisco FRP 4140 box with FTD image 6.0.1, can any one help me how to register Cisco 4140 box to Firepower Management ?

Can anybody tell me step by step procedure with commands in FRP 4140 side?

Thanks in Advance

1 Accepted Solution

Accepted Solutions

Oliver Kaiser
Level 7
Level 7

You have so assign an ip address to your mgmt interface and configure the fmc connection with a registration-key matching on both ends

e.g.

> configure network ipv4 manual <ftd-management-ip> <subnetmask> <default-gateway>

> configure manager add <fmc-ip-address> <registratation-key>

You may check registration status using the following command:

> show managers

View solution in original post

1 Reply 1

Oliver Kaiser
Level 7
Level 7

You have so assign an ip address to your mgmt interface and configure the fmc connection with a registration-key matching on both ends

e.g.

> configure network ipv4 manual <ftd-management-ip> <subnetmask> <default-gateway>

> configure manager add <fmc-ip-address> <registratation-key>

You may check registration status using the following command:

> show managers

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: