05-24-2022 01:01 PM
Hello Team,
I got two Cisco FTDs being managed by Cisco FMC. I'm looking for a way to monitor the interfaces (inside and outside) of both FTDs when there is change in their status i.e. Up, Down, when there is no traffic passing through them etc.
I have installed a free version of Kiwi Syslog and configured SNMP in FMC under platform settings but unfortunately I'm not receiving any data on Syslog server. Am I missing something? Or maybe there are other ways to achieve this.
Thanks & Regards,
Sam
Solved! Go to Solution.
05-24-2022 01:06 PM
@IamSamSaul well SNMP is what you need to monitor the device and get interface information. You wouldn't use a SYSLOG server when using SNMP for monitoring, you need an NMS that supports SNMP, such as PRTG or Solarwinds
Platform Settings is the correct place to configure SNMP settings.
05-24-2022 01:06 PM
@IamSamSaul well SNMP is what you need to monitor the device and get interface information. You wouldn't use a SYSLOG server when using SNMP for monitoring, you need an NMS that supports SNMP, such as PRTG or Solarwinds
Platform Settings is the correct place to configure SNMP settings.
05-24-2022 01:09 PM
Thanks Rob for your reply. I'll install a trail version of PRTG (free for 100 sensors) and see I can get it working.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide