cisco switch CBS350 commands not supported
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-06-2023 04:12 AM
Hi all,
I have Cisco switch CBS350 (I hate this switch because of different CLI commands).
I need to delete switchport configuration (like this: "default interface fa0/0"), but "default" command not works. I couldn't find specific command for it. Can you tell me please how can I delete the configuration on siwtchport?
- Labels:
-
Other Network Security Topics
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-06-2023 04:23 AM
the command only available on enterprise switches, these models have limited - below only command available.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-06-2023 06:09 AM
Why did Cisco make a SHEET like this switch? :((
I cant delete port-chanel also.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-06-2023 10:19 AM
I cant delete port-chanel also. < not sure what command you tried ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-28-2023 05:51 AM
Good morning.
I have it too, and I hate it. So, you can't enter "default interface <interface>". Why? I don't know, but I think this ridiculous.
For enter default configuration on the CBS350, you can use the commands "no switchport trunk" or "no speed" or "no duplex", anything. One by one.
I'm really sorry. I'm suffer from this too.
