Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am trying to make Cisco ISE HA. On the Cisco site, I did not find a user manual for it.I have cloned the main ISE 3.1.0 and changed the IP.I am trying to make HA:Administration > Deployment > Register (FQDN, user, password)But I have this error...
Hi guys,I need to set up the priority of network traffic:1. VoIP (sensitive) (Cisco and Grandstream phones)2. RDP (medium sensitive)3. all other internet traffic (not sensitive)VoIP and RDP traffic go to servers through VPN tunnels.Internet traffic i...
Hi all,My branch Switch Cisco WS-C3560 cant do NAT therefore traffic goes to the internet through the tunnel.This tunnel with ISR4321 is without encryption because the branch switches do not support encryption.Here is no firewall and traffic is not f...
Hi all,I have Cisco switch CBS350 (I hate this switch because of different CLI commands).I need to delete switchport configuration (like this: "default interface fa0/0"), but "default" command not works. I couldn't find specific command for it. Can y...
Hi guys,I have FCM with 2 clusters of FPR (active-standby) you can see on the screen:I am not able to connect with SSH. I Tried connecting with SSH (putty) to all four IP addresses: (192.168.5.38, 192.168.5.34, 192.168.5.37, 192.168.5.33), but witho...
In my case with cisco C8200-1N-4TC8200#conf tC8200(config)#license boot level network-advantageC8200(config)#do writeC8200(config)#do reloadthis helped.
