05-06-2015 01:15 AM - edited 03-12-2019 05:40 AM
Hi
We have a new install thats still in learning mode. I have an alert on the DC for one of the sensors saying that s1p1 - s1p4 has no link.
We have an active/standby ASA pair behind the sensor. and 2 nexus's in front. One nexus connects to s1p1 and s1p2 connects to the asa and same for the other using s1p3 and s1p4.
the DC is showing no link on any of the 4 ports and from the sensor gui the interface traffic graph only shows traffic on eth0. I can connect to the active asa but not the standby. This should show traffic on the graphs but nothing. Both asa and nexus interfaces are connected. I tried to set s1p3 and s1p4 to propagate link state yesterday, After applying the task seems stuck in polling and has been like this over night.
Anyone any ideas or need more info.
Thanks
Lee
01-18-2016 08:29 AM
Hi Lee,
Probably the traffic is only for manegement interface eth0 and not for any other ports.
Did you check in sensor CLI/GUI if it is showing interface in enabled state ?
Thanks,
Ankita
02-08-2016 02:10 AM
Agreed that In all likelihood, the action is only for management interface eth0 and not for some different ports.this might hurt sources too. website
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide