03-12-2023 07:36 PM
Hi,
I want to deploy ASA with HA Active/Passive in FirePower 4112.
When deploy the ASA instance in FirePower, do I need to select 'Cluster' as device mode? Or just select standalone and then configure the HA in the ASA CLI?
Thanks
Arie
Solved! Go to Solution.
03-13-2023 01:14 AM
For active passive you want to select standalone and then configure HA failover. Clustering something different where traffic is load-balanced between the ASAs in the cluster.
03-12-2023 07:46 PM
Configure FTD High Availability on Firepower Appliances - Cisco
check this guide
03-12-2023 08:27 PM
Hi,
Does the guide also applicable for ASA image?
Thanks
03-13-2023 01:14 AM
For active passive you want to select standalone and then configure HA failover. Clustering something different where traffic is load-balanced between the ASAs in the cluster.
03-13-2023 02:19 AM
Hi,
Oh I see, so I don't need to configure cluster in FMC for ASA image, just configure usual HA failover in ASA CLI, is it correct?
Thank you
03-13-2023 02:26 AM
correct
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide