Trying to trigger EEM when 'ip sla reaction-configuration <nnn> react timeout threshold-type consecutive 5' is exceeded.
If not using consecutive, can use syslog or snmp mib to detect when RTT threshold is exceeded.
Cannot work out how to detect when 'consecutive' is used.
Details: ASR1002 Software: asr1000rp1-ipbasek9.03.02.01.s.151-1.s1.bin
Did you configure a timeout value in your 'ip sla x' config?
ip sla 1
timeout 1000 <--------Here is your timeout
The 'consecutive' count is based on this value, once the timeout value is met 5 consecutive times, it should trigger. No special configuation is required for this.
Thansk for the reply. RTT is working OK with 'consecutive' count.
My issue is how to detect it has triggered with EEM.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: