peterbe
Beginner
Beginner
Member since ‎08-27-2002
‎08-18-2017

User Statistics

  • 52 Posts
  • 4 Solutions
  • 5 Helpful votes Given
  • 11 Helpful votes Received
Recent Badges
1 Accepted Solution
10 Helpful Vote
1 Helpful Vote
20 Replies
10 Replies
5 Replies

User Activity

HiWe need to use the same user IDs  for both 802.1X and VPN access:    802.1X authentication request from local switch will use AD   VPN authentication request from VPN device will use RSA I am OK with NDG to determine what device request comes from....
We currently have the interfaces configured with 'mtu 9216'. Now we are adding a policy-map type network for the data and iSCSI classes.  Where do we set mtu - see exampleinterface e8/1 mtu 9216  << with this set, do we need to specify mtu in the po...
We are using EEM to increase OSPF cost on primary link if OSPF flaps a couple of times in 5-minutes or IPS SLA detects an issue.  The traffic then uses an alternate link until OSPF cost is retutned to normal.Now we want to automate restoring OSPF cos...
HiTrying to trigger EEM when 'ip sla reaction-configuration <nnn> react timeout threshold-type consecutive 5' is exceeded.If not using consecutive, can use syslog or snmp mib to detect when RTT threshold is exceeded.  Cannot work out how to detect wh...
HiUsing CBWFQ with access-lists to match traffic assigned to classes. If access-lists are not very specific, what happens to traffic that is matched by 2 or more access-lists i.e. traffic could be put multiple classes?What is the process for the rou...
Community Statistics
Member Since ‎08-27-2002 08:38 PM
Date Last Visited ‎08-18-2017 04:00 AM
Posts 52
Total Helpful Votes Received 11
Helpful Votes From
Helpful Votes Given To