07-28-2011 09:55 PM - edited 02-21-2020 04:24 AM
Hi
Trying to trigger EEM when 'ip sla reaction-configuration <nnn> react timeout threshold-type consecutive 5' is exceeded.
If not using consecutive, can use syslog or snmp mib to detect when RTT threshold is exceeded.
Cannot work out how to detect when 'consecutive' is used.
Details: ASR1002 Software: asr1000rp1-ipbasek9.03.02.01.s.151-1.s1.bin
Any suggestions?
Peter
07-29-2011 10:52 AM
Did you configure a timeout value in your 'ip sla x' config?
ip sla 1
!-----output omitted-----
timeout 1000 <--------Here is your timeout
The 'consecutive' count is based on this value, once the timeout value is met 5 consecutive times, it should trigger. No special configuation is required for this.
07-31-2011 04:25 PM
Thansk for the reply. RTT is working OK with 'consecutive' count.
My issue is how to detect it has triggered with EEM.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide