cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1022
Views
0
Helpful
2
Replies

eem and ipsla reaction-configuration consecutive

peterbe
Beginner
Beginner

Hi

Trying to trigger EEM when 'ip sla reaction-configuration <nnn> react timeout threshold-type consecutive 5' is exceeded.

If not using consecutive, can use syslog or snmp mib to detect when RTT threshold is exceeded. 

Cannot work out how to detect when 'consecutive' is used.

Details:  ASR1002  Software: asr1000rp1-ipbasek9.03.02.01.s.151-1.s1.bin

Any suggestions?

Peter

2 Replies 2

Antonio Knox
Rising star
Rising star

Did you configure a timeout value in your 'ip sla x' config? 

ip sla 1

!-----output omitted-----

timeout 1000 <--------Here is your timeout

The 'consecutive' count is based on this value, once the timeout value is met 5 consecutive times, it should trigger.  No special configuation is required for this.

Thansk for the reply.  RTT is working OK with 'consecutive' count.

My issue is how to detect it has triggered with EEM.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers