Network Security

Hello experts,I am not an expert in security and network so please help me with my below query.I have a ASA 5520 V 7.0(4), the Inernet link is terminated on a router --> switch---> ASA G0/2. The ASA 5520 is connected to the L3 i.e. G0/1--->L3.Normall...

Hi,Our charter school is a public 501(c)(3) non-profit K-12 school in California, and as such my technology budget in this economy is thinner than ever!We have to keep older technology going, and I just don't have the luxury to upgrade my PIX's to AS...

Hi,the module  WS-SVC-FWM-1 its comming up at the 6509-E chassis.i did try set up the CF to 4 but the module only shows power down, also i have tried change for cf:5 but still not working.i have setup the boot devivce, have tried reset the module and...

Hi,In order to configure the Lan to Lan VPN on ASA with code 8.4 how do we configure no-nat or nat 0 so that matched packets will not undergo any natting.Following link shows the example but it is not showing the how NAT exemption is to be configured...

How to Configure "Incorrect password Attempts  Disable login for 30 minutes after 3 successive failed attempts" on ASA-5510???

We configuring ASA 8.4.2 in Active/Standby failover mode with two cables. What would be the best design configuring etherchannel on ASAs or have one active and one standby redundant cable ?

Hi,I'm trying to setup port mirroring on a Cisco ASA 5510, but when I try to use the switchport monitor command, that command is not recognized.I've selected what interface I want to configure (conf-if), but the switchport command seems to not be par...

HiI have remote site in which site to site vpn is configured with hub site using 5510 model. now i am using load balancer in which 2 isp will terminateone is isfy and other is reliance . now i want if suppose ipsec-tunnel is configured primary with s...

I have set up a LMS4.0 and add devices into DCR.All my Cisco 2900, 3750, could be recogized by LMS 4.0 and could be do action in inventory list, such as viewing EOS/EOL info, etc.However, my cisco 4500 is fail to recogize by DCR. And the device icon ...

Hello,When configuring IDSM2 in Cat6K, there is a command with parameters of data port:# monitor session 1 destination intrusion-detection-module 9 data-port 1What does the data-port mean? does it mean the monitoring interface 7 or 8?Thanks,-Alejin

Hi,I have a CentOS 5.7 VSFTP server behind of a Cisco ASA 5505 (dmz network) which is doing NAT. Clients outside the firewall cannot access the server with passive ftp.   They initiate a ftp session and as soon as the ftp client issues the  pasv comm...

Hi All,  Scenario:-  i) 2 ISP on 2 different routers.  ii) 2 ASA (each ASA is connected to each routers directly)                               ISP1                   ISP2                                 |                       |                     ...