EIGRP Issue Connecting Two ASA int to Two Router Int

[mlenco]

On a router I get an EIGRP can't find upstream IP and vice versa on the ASA as I have two FA plugged into two Gig E (stepped down) on the ASA. There are two tunnels going out both interfaces but I get these errors simply pinging from the upstream routers.

Any ideas about the EIGRP error?

[ajagadee]

Can you post the exact messages that you are seeing from the Pix and router. Also, are you trying to configure EIGRP across the IPSEC Tunnel.

Regards,

Arul

[mlenco]

EIGRP% Cannot find adjacent neigh IP address.

I have eigrp network statements on the ASA and router but I haven't configured any routing commands on the tunnel.

[mlenco]

Heres the error message:

Feb 04 2008 18:09:22: %ASA-5-336010: EIGRP-IPv4: PDM(334 10: Neighbor 50.0.4.1 (

GigabitEthernet0/3) is up: new adjacency

The Cisco Security Appliance System Log Messages, Version 8.0

Gives me this which isn't very helpful...

336010

Error Message %ASA-5-336010 EIGRP- tableid as_id: Neighbor address (%interface) is event_msg: msg

Explanation Neighbor Change. A neighbor went up or down.

•ddb_name-IPv4

•tableid- internal ID for the RIB

•as_id-autonomous system ID

•address-IP address of the neighbor

•interface-Name of the interface

•event_msg- Event that is occurring for the neighbor (that is, "up" or "down")

•msg-Reason for the event. Possible event_msg and msg value pairs include:

-resync: peer graceful-restart

-down: holding timer expired

-up: new adjacency

-down: Auth failure

-down: Stuck in Active

-down: Interface PEER-TERMINATION received

-down: K-value mismatch

-down: Peer Termination received

-down: stuck in INIT state

-down: peer info changed

-down: summary configured

-down: Max hopcount changed

-down: metric changed

-down: [No reason]

Recommended Action Check to see why the link on the neighbor is going down or is flapping. This may be a sign of a problem, or a problem might start occurring because of this.