Network Security

hello experts, my firewall has to wan interfaces wan1 and wan2, each one connected to a dsl router. and i configured the rules on the pix firewall to allow outgoing traffic from the lan out wan1 and wan2 but i discovered that wan1 only can connect th...

Hi,Is it unusual to see a Pix515 with 256MBof RAM? Is it even possible? See below:iscoPix> sh verCisco PIX Security Appliance Software Version 7.0(7)Compiled on Fri 06-Jul-07 10:37 by buildersSystem image file is "flash:/pix707.bin"Config file at boo...

Hello,I can't seem to get the ASDM to connect and display the IPS (ASA-SSM-10). I continue to get the "error loading module" when trying to connect via the ASDM. The command and control interface (G 0/0) is connected to the local net and is pingable ...

I have a customer with two ASAs; in Active/Standby. They want to purchase one AIP. Will failover (without the AIP functionality) to the Standby work if the AIP is configured for Promiscuous mode? Thanks, Bob

hi ,I need help, Can IDS event viewer version 4.1 monitor the IDS-4235-K9 with version 5.1-5-E1 ?

Hi There,We are currently looking at building out our Data Center to support a managed backup solution for multiple clients. We are currently looking at pushing the backups through a pair of ASA5580-20 appliances, however I have concerns as I haven't...

What command for PIX is equivalent of logging synchronous for router. I would synchronize typed characters with output from logging.Thanks a lotnowy

Hi All,i was reading the config guide for the Cisco PIX Version 6.3 IOS, i noticed there is no clear procedure for downgrading the cisco pix from this version to version 6.0.there is a procedure for downgrading to version 4 and 5.here is what in the ...

Questions: is there a way to create a network group using wildcard? I need to allow access on a 10.0.0.0/8 network that is segmented in 4000 smaller network. However, within these smaller networks only the 10.*.*.11 need to use port (21,137,443). Is ...

Hi guys,I have 2 firewalls ASA5550 in failover mode, in the data sheet says that maximum throughput is 1.2G, but when the outside firewall traffic comes up to 750Mb, i start to have a lot of problems, like packet drops. When the traffic arrives at 80...

Hi, i have two 3845 router with AIM-VPN/SSL-3 running C3845-ADVIPSERVICESK9-M. i have configured HSRP on this router. Remote site establish tunnel with this HSRP IP. I want to know whether stateful failover can be configured between this two routers....

How are the restricted license applied. If I have a 5505 how do you know if you exceed the 10 user restriction