Enable Telnet to PIX 7.0(2) form outside interface

[e.deangelis]

Hi,

how to enable telnet to pix outside interface.

I try to connect with telnet to a router in outside lan and then i would connect with telnet form router to pix.

Router have ip address 10.10.10.1 and Pix device have ip address 10.10.10.2.

I have tried to write this command:

telnet 10.10.10.1 255.255.255.255 outside

but doesn't work.

Why?

Thanks

[spremkumar]

Hi

I would suggest u to go thru this link ...

Query inline with urs :-)

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Security&topic=Firewalling&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1dd9d0ea

regds

[Patrick Iseli]

Telnet is not allowed directly on the outside interface. You need to setup VPN to connect with telnet ! See this example.

Allowing a Telnet Connection to the Outside Interface :

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a0080172797.html#wp1064460

sincerely

Patrick

[rsmith]

I would forget Telnet, and use SSH (Teraterm has a good client). Use the document in Patrick's link for information on this.