07-14-2024 01:27 AM
Hello everyone,
I'm having a problem with my FPR 1000 series firewall, it was working before a long blackout happens, now when the electricity got up the firewall is acting up like this.
Both of the port eth1 and eth2 are blinking at the same time and is kind of unusual, I can't ping the firewall ip and can't even access the management port directly(it doesn't glow up as seen on the video).
Thanks.
Solved! Go to Solution.
07-14-2024 02:50 AM
it seem that the firepower is not boot correctly becuase the register number is wrong
this make all config is remove and hence you can not access nor link is UP
MHM
07-14-2024 01:47 AM
@Edgieace hi, what about your status light? third light at left upper corner. is it blinking?
07-14-2024 02:50 AM
it seem that the firepower is not boot correctly becuase the register number is wrong
this make all config is remove and hence you can not access nor link is UP
MHM
07-15-2024 01:20 AM - edited 07-15-2024 01:27 AM
Is there something that is not working? Three quick flashes on the port means that it is 1Gbps speed. So unless you are experiencing any actual issue then this is normal behavior. See the snippet I have posted below along with the link to documentation.
Network
Status of the network ports.
Connection-speed status (S):
Green, flashing—One flash every three seconds = 10 Mbps.
Green, flashing—Two rapid flashes = 100 Mbps.
Green, flashing—Three rapid flashes = 1000 Mbps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide