Hello everybody,
our customer has a Firepower 1010 running OS rel. 6.6.5.1
and is working with the FDM.
I have configured a further S2S-tunnel and thereafter I had to
deploy the new configuration.
As the deployment did not work I checked the deployment history.
Already before this config change the deployment failed several times
(screendump attached).
For the error message:
"Deployment failed because exporting the Sensor configuration failed"
I just found a single bug CSCve44262 but the affected release there
was 6.2.2. There are just 28 rules on the FTD and they don't use
application filters.
Has somone an idea how to get rid the error message so the deployment
is working again?
If needed I can upload the troubleshooting file of the Firepower 1010.
Thanks a lot for every hint!
Bye
R.
