11-06-2017 02:28 PM - edited 02-21-2020 06:39 AM
Hi All,
I need to install a Cisco FTD 2100 series appliance to sit inline between our Cisco ASA firewall and LAN switch. The Cisco ASA is connected to the LAN switch using 2 x 1GbE interfaces that are bundled in a port channel.
To ensure that the FTD inspects traffic over both ASA port channel member interfaces, I'm assuming that I need to configure 4 inline interfaces on the FTD (one pair for each port-channel member link) and then place them all in the same inline set? Could someone please confirm?
11-10-2017 06:35 AM
03-14-2018 08:04 AM
Hi Will,
I have the same doubt as you.
Did you get an answer to your question?
Regards
12-14-2019 10:04 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide