cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1263
Views
0
Helpful
2
Replies

Firepower RAVPN with Outside interface using private address

jdonjuanl
Level 1
Level 1

Hello, we are implementing a RAVPN solution with Firepower and the scenario is:
-We have a x.x.x.x/30 for RAVPN solution
-Firepower Outisde interface is using private address y.y.y.y/30 and is connected to a Internet Router inside interface
-Internet Router is also using private addressing for inside and outside interfaces
-Internet Router has a static route indicating the x.x.x.x/30 lives in the firewall and the next-hop is the Firepower Outside interface.

 

LAN <---> FP <----> Router <-----> Internet

 

It is possible to deploy RAVPN in this scenario?
Can anyone send any documentation to implement it?

 

Regards

1 Accepted Solution

Accepted Solutions

jdonjuanl
Level 1
Level 1

As far I can tell it is not possible

 

Regards

JCD

View solution in original post

2 Replies 2

jdonjuanl
Level 1
Level 1

As far I can tell it is not possible

 

Regards

JCD

Cristian Matei
VIP Alumni
VIP Alumni

Hi,

 

   If you can't assign the public IP to the FTD directly, you can configure the router in front of the FTD to perform NAT, and make the FTD private address visible as the public address to the Internet.

 

Regards,

Cristian Matei.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: