03-29-2007 11:50 PM - edited 03-11-2019 02:53 AM
Hello
I have a firewall (in this case a context within a FWSM, but I guess this applies also to any ASA) with only internal interfaces. That is, no interface is connected to internet, and there is no need for any address translation thru the fw.
What do I need to do to configure the firewall to not bother about NAT/PAT at all, and forward traffic only based on ACL:s?
The command "no nat-control" is a good start. But is there more that needs to be done?
Best regards
Jimmy
Solved! Go to Solution.
03-30-2007 12:35 AM
Hi Jimmy
That command will pretty much do it. Make sure once you have entered this command that you then don't have any nat/global statements as these would still be executed.
HTH
Jon
03-30-2007 12:35 AM
Hi Jimmy
That command will pretty much do it. Make sure once you have entered this command that you then don't have any nat/global statements as these would still be executed.
HTH
Jon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide