Network Security

I wrote a rule with the intent of it firing upon events originating only from public ip addresses AND only for yellow OR red severity levels. However this rule still fires on green severity events. Can any one see why from looking at the rule in the ...

Hi Glen I have configured VPN on pix 501 ver 6.3(5) for windows using pptp. Users logon successfully but cannot access any of the internal network IP. below is my config. PIX Version 6.3(5)interface ethernet0 autointerface ethernet1 100fullnameif eth...

Is the Pix 525 capable of being configured with multiple outside interfaces? If not, then I would assume I can assign a different security level to a new interface. We terminate all of our site to site VPN connections on the Pix 525 and due to latenc...

Could anyone tell me which is the MIB to monitor CPU usage of IDS?Thank you, Cristina

We are currently putting together a solution that I have come in halfway through just after some assistance in regards to setting up the IDS. We have 2 * 6509 chassis, 2 * IDSM-2 modules. Scenario 1 - Both IDSM-2 Modules in primary chassis, can load ...

Dear I am not getting the right answer. I am not asking about the signeture but I am asking how to include the action taken by the IPS into the alarm email sent to us, so we know what action was taken by the IPS regarding this signeture. Currently , ...

Hello,I have been trying to connect a VPN Client for remote access to a PIX515E (using version 7.2(2). I can get to the user authentication window, but after I enter the username and password, I get the status "Not Connected". I tried to run "debug c...

I have two identical VMS 2.3 servers, with all current OS and VMS Patches applied. When the SecMon 2.2 Service Pack 2 is applied, all the generated reports "Count" field (the number of instances a particular signature fired) shows a value of ZERO. In...

Hi, I have a new 5510 that I have enabled smtp service but when I try to telnet to the firewall port 25 the display is just garbled characters and it wont allow the connection to my server. What could I be missing in the config?

Hello,In an attempt to make my network more secure I closed TCP port 3389 for terminal services and enabled VPN access. I did the wizard that is in the PDM to configure the VPN. I was able to connect securely and access the servers. However I was not...

I can?t loading PDM in my browser of the PIX 515EI have the next configuration:http server enablehttp 10.1.6.1 255.255.255.255 insideTks.

can we install on the ASA5540, 1 x ASA-SSM-AIP-20-K9 + 1xSSM-4GE, at the same time?