Flex-Config PBR Config Lost - FTD

[ConstantNSAH8220]

Hi guys,
We are running FMC/FTD (Cisco ASA 5516-X) with the version 6.4.0.6.
We have created successfully a flex-config PBR: it worked correctly.
The next day, it stopped working and we have checked the configuration from the FTD in cli mode, and one part of the config was missed (set ip next-hop A.B.C.D)
--------------------
ASA5516N# show run route-map
!
route-map rtm-pbr permit 10
match ip address acle-pbr

!
------------------------
We have reapply the configuration.

Today, we faced with the same issue, without any operation, the "set" command in the route-map has been lost to FTD

I suspect that this is a bug. Does someone has already faced with the same issue?

Regards

[ConstantNSAH8220 · Accepted solution]

Hi,

I have opened a case with TAC and they solved the issue.

I share the solution that is documented in the url https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvg84351